RDI transform Instrucciones De Instalación página 29

INSTALLING TOP RAIL
15.
Using a 1/ " drill bit, pre-drill downward
8
through the top beam and bracket (Fig. 21).
If needed, an additional rail stiffener
(component F) can be purchased separately,
and installed in place in top rail (component
A) as shown below.
If using stiffener,
insert into top of
top rail as shown.
Stiffener shape will
vary based on top
rail profile.
16.
Snap the top rail (component A) onto the top
beam (component D) by applying downward
pressure. Work from the bottom of the stair
to the top end of the rail until the full length of
the cover locks into place (Fig. 22 & Fig. 23).
(Fig. 21)
17.
Using the painted screws (component
M) install two of the screws upward from
underneath each end through the pre-drilled
location (Fig. 24). This will secure the bracket,
beam, and top rail together (Fig. 25).
(Fig. 22)
(Fig. 23)
(Fig. 24)
(Fig. 25)
½"
29