RDI transform Instrucciones De Instalación página 15

PREPARING POSTS
4.
Determine placement of your top beam
(component D). Make a mark at 33
deck surface for 36" finished rail height or
39 " from deck surface for 42" finished rail
∕
3
8
height.
Clamp your top beam in place on your posts
so that the bottom of your top beam lines up
with your marks. Mark the top beam at the
angle where it will need to be cut (Fig. 4).
5.
The mid-baluster support (component E) is
∕ " from REQUIRED for cable spans over 42".
3
8
Center the mid-baluster support between your
top beam and bottom rail at the top stair post
to determine even spacing of holes (Fig. 5). For
this application, up to 9 holes will be used for
cable runs for a 36" finished rail height, and up
to 11 will be used for a 42" finished rail height.
Mark on your mid-baluster support the angle
at which to cut it at both ends (Fig. 6). Cut your
mid baluster support at these marks.
NOTE: Both ends of your mid baluster support
will need to be cut on the angle to attach to the
top beam and bottom rail.
(Fig.4)
6.
Using your cut mid-baluster support as a
template, line it up at the top and bottom of
your stair posts and mark your holes using a
pencil (Fig. 7).
Determine the placement of your mid-baluster
support along your cable span, and mark your
top beam and bottom rail where the mid-
baluster support will attach (Fig. 8). Un-clamp
your bottom rail and top beam.
(Fig. 5)
(Fig. 6)
(Fig. 7)
(Fig. 8)
15