RDI transform Instrucciones De Instalación página 25

MID BALUSTER SUPPORT (NO BOTTOM RAIL)
4.
Take your mid-baluster support, cut to length,
and place in the middle of your cable span.
Move the support along the tread of the step
so that the top of it meets your top beam (Fig.
4). This placement will vary based on stair
angle.
5.
Make a mark on your top beam where the mid-
baluster support is centered (Fig. 5). Un-clamp
your top beam. Using the mid-baluster support
foot (component O) as a template, mark the
holes in your top beam where it will attach, and
using a 3/ " drill bit, pre-drill the holes in your
16
top beam (Fig. 6 and Fig. 7).
(Fig. 4)
6.
Using your cut mid-baluster support as a
template, line it up at the top and bottom of
your stair posts and mark your holes using a
pencil (Fig. 8).
(Fig. 5)
(Fig. 6)
(Fig. 7)
(Fig. 8)
25