Grundig WK 7280 Manual Del Usuario página 14

OPERATION _________________________________
Preparation
1
Clean kettle well before initial use and discard
the water of first two boiling cycles.
Operation
1 Push the lid release button
open the lid .
C
2 Fill the water tank
G
Notes
Do not place the water tank
7
H while filling it with water.
Never fill the water tank
7
mum level indicator or below the minimum
level indicator.
3
Close the lid until it clicks into place.
C
4 Place the water tank
sure that it is sitting in an upright and stable
position.
5
Insert the plug into the wall socket.
6 Select the desired temperature by pressing the
selection button . As the button
K
the temperature selection will cycle from 100
to 80, 60, 40 and back to 100 again.
– The temperature indicator light
7 If desired, the simmer function can be acti-
vated by pressing button
– Indicator light of button
Notes
When pressing the simmer function button
7
in stand by mode without selecting the de-
sired temperature, the indicator light of button
will go off after 10 seconds.
I
8 Push On/Off button
– Indicator light of On/Off button
and the boiling process begins.
– When the appliance is in operation, indica-
tor light of the set temperature will flash.
Meantime, current water temperature will
be indicated by the relevant temperature
indicator light until the set temperature is at-
tained.
14 ENGLISH
on the kettle to
D
with water.
on the base
G
above the maxi-
G
on the base . Make
H
G
is pushed
K
will flash.
L
.
I
lights on.
I
I
.
J
lights on
J
Note
Lid should always be closed during the
C
7
boiling process; otherwise the kettle will not
switch off automatically.
The desired temperature can be changed or
7
set during the boiling process by pressing tem-
perature setting button
9 When the desired temperature is reached, the
indicator light of On/Off button
and the kettle stops operating.
– After 60 seconds the temperature indicator
lights go off and the kettle returns into
L
stand by mode.
Notes
If you want to stop the boiling process manu-
7
ally, push the On/Off button
If the simmer function is activated, the kettle
7
will restart the boiling process when the tem-
perature falls below the desired temperature.
After 30 minutes, simmer function will be can-
celled automatically.
10
Disconnect the plug from the wall socket.
11
Take the water tank from the base
hold it by the handle
Caution
Do not open the lid
7
splash out. Make sure that no water splashes
onto the base .
H
12 Pour the water from the spout
or glass you want to use.
Note
Let the kettle cool down between each heat-
7
ing process.
Hints and Tips
The kettle is equipped with a water filter
7
which filters out limestone and other residues
when the water is being poured out.
Use softened or filtered water to prevent lime
7
build-up.
.
K
goes off
J
.
J
. Only
H
.
E
as hot water could
C
to the cup
A
B