Idiomas disponibles
Idiomas disponibles
Installing the Lowback
3. Align the back panel of the new accessory with the
flanges on the range side panels right and left rear
corners. The backguard is inserted inside the guide
channels on the back of the range.
4. Make sure the backguard's front face is outside the
flange on the front side of the range.
5. Re-install screws removed in Steps 1 and 2.
Toe Kick Panel (PA [36,48] JTKG)
Toe Kick Parts Included
1 – Toe Kick Panel
4 – T-20 Torx drill point screws
Tools Needed
T-20 Torx head screwdriver or drill
Protective work gloves
English 2
Remove the Front Foot Cover Assemblies
1. Remove the (2) T-20 Torx head screws securing the
foot cover assembly to the range base, as shown in the
figure below. Repeat for the other front foot cover
assembly
2. Remove the leg covers by sliding the top, outer sleeve
of the leg covers off the extruded dimples of the base.
Installing the Toe Kick Panel
3. Remove protective plastic covering from the Toe Kick
Panel.
4. Beneath the range, with the holes and flange facing up,
wrap the Toe Kick Panel around the base.
5. The mating part has extruded dimples on both sides for
which the holes of the Toe Kick Panel should seize.
You should feel a definitive snap, letting you know that
the part has been installed.
6. Mount the Toe Kick Panel on both sides of the unit into
the extruded dimples using the (4) T-20 Torx drill point
screws provided.
9001078742 • Rev. A • 5U06U8 • © BSH Home Appliances Corporation, 05/15
.
