How To Hang Your Head Assembly - Fanimation MA7966 Serie Manual Del Propietário

1. Remove the four screws from the pulley assembly
mounting cover by using the supplied allen wrench.
Retain the screws for reinstallation in Step 4. (Figure 1)
2. Paste the pilot hole paper onto the plywood. (Figure 2)
3.
supporting member to prevent splitting or cracking.
lag bolts and flat washers. The lag bolt will pass through
the flat washer and into the building structure. (Figure 3)
4. Assemble the pulley assembly mounting cover using
the previously removed screws and securely tighten all
screws. (Figure 4)

How to Hang Your Head Assembly

HARDWARE USED:
ALLEN
WRENCH
1/8 x 60 x 20 mm
Pilot Hole Paper
Plywood (¾ thick min.)
Backing Secured to
Structural Member
Pulley Assembly
HARDWARE USED:
LAG BOLT
FLAT WASHER
11
Pulley Assembly
Mounting Cover
Allen Wrench
Figure 1
Plywood
Figure 2
Figure 3
x 4
x 4
Figure 4