How To Hang And Wire Your Motor Assembly - Fanimation MA7966 Serie Manual Del Propietário

How to Hang and Wire Your Motor Assembly

The fan must be hung with at least 7´ of clearance from
floor to blades. (Figure 1)
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before hanging.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
The outlet box must be securely anchored and capable
of withstanding a load of at least 35 lbs. Hanger bracket
must seat rmly against outlet box. If the outlet box is
recessed, remove wallboard until bracket contacts box.
If bracket and/or outlet box are not securely attached,
the fan could wobble or fall.
1. Securely attach the ceiling junction box acceptable for
fan support into the building structure. Junction box
is not supplied with the fan. (Figure 2)
2. Remove the four screws and hex nuts with flat washer
from the ceiling plate assembly. Retain the screws, hex
nuts and flat washers for reinstallation in steps 7 and 8 of
page 10. (Figure 3)
INSTALLATION NOTE
It is recommended that each fan and the motor have
adequate support . A 120 VAC electrical feed, centered
(supplied) is required.
more than 4 head/blade assemblies.
base or supporting member to prevent splitting or
cracking. Mount the ceiling plate assembly on the
ceiling with four pan head wood screws and flat
washers. (Figure 4)
WARNING
WARNING
WARNING
Floor
NOTE: Supply wires
omitted for clarity
Outlet Box Flush
to Finished
Ceiling
HARDWARE USED:
#6-18 x 1.5
PAN HEAD
WOOD SCREWS
FLAT WASHER
8
Ceiling
less than
7 ft
Figure 1
Outlet Box
Figure 2
Figure 3
Plywood (¾ thick min.)
Backing Secured to
Structural Member
Ceiling Plate
Assembly
Figure 4
x 4
x 4
No