Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Add Engine OiJ
1.
Place pressure washer on a fiat, bvei surface.
2.
Cleanarea around oii fiii and remove yeiiow oii fiii
cap/dipstick.
NOTE:See Oil Recommendations in Maintenancesection.
Verify provided oii bottle is the correct viscosity for current
ambient temperature.
3.
Using oiI funnel (optional), slowiy pour contents of
provided oil bottie into oil fill opening.
Improper treatment of pressure washer can damage it and
shorten its life.
DONOT attemptto crankor startthe enginebeforeit hasbeen
properlyservicedwith the recommended o il This may resultin
an enginefailure
4.
Replace oil fill cap/dipstick and fully tighten.
Add FueJ
Fuel must meet these requirements:
,
Clean, fresh, unleaded gasoline.
,
A minimum of 87 octane/87 AKi (91 RON). High altitude
use, see High A/titude.
,
Gasotinewith up to 10% ethanoi (gas@@ or up to 15%
MTBE (methyl tertiary butyl ether) is acceptable.
Avoid pressure washer damage.
Faiiureto foiiow Operator's Manuai for fuel
recommendations voids warranty.
DONOTuseunapproved gasolinesuchas E85.
DONOTmix oil in gasoline.
DONOTmodifyengineto run on alternate fuels.
To protect the fuel system from gum formation, mix in a fuel
stabiiizer when adding fuel. See Storage. Ali fuel is not the
same. if you experience starting or performance probiems
after using fuel, switch to a different fuei provider or change
brands. This engine is certified to operate on gasoiine. The
emission control system for this engine is EM (Engine
Modifications).
WARNING
FueIand its vapors are extremely fiammabb and
explosive.
Fire or explosion can cause severe burns or
death.
WHENADDmNG FUEL
o Turnpressure washerOFF and let it coolat least2 minutes
beforeremovingfuelcap. Loosencapslowly' t o relievepressure
in tank.
o Fillfuel tankoutdoors.
• DONOToverfilltank.Allowspacefor fue! expansion.
o If fuel spills,wait until it evaporates beforestartingengine.
• Keepfuelawayfrom sparks,openflames,pilot lights,heat,and
otherignitionsources.
o DONOTlight a cigaretteor smoke.
1.
Cieanarea around fuel fiii cap, remove cap.
2.
Siowiy add regular unleaded fuel (A) to fuet tank (B). Be
carefui not to overfiii. Aiiow about 1.5" (4 cm) (C) of tank
space for fuel expansion.
CAUTION! AIcohoI-blendedfuels (caibd gas@oI, ethanoi or
methanol) can attract moisture, which leadsto separation and
formation of acids during storage. Acidic gas can damagethe
fuel system of an engine while in storage.
To avoid engine problems,the fueI system should be treated
with a fuel preserver or emptied before storage of 30 days or
longer, if adding a fuel preserver, fiii the fuei tank with fresh
fuel. if only partiaiiy filied, air in the tank wiii promote rue!
deterioration during storage, if fuet preserver is not used,
drain the rue! tank, start the engine and bt it run untii the fuel
fines and carburetor are empty. Use fresh fuel next season. See
Storagefor additionalinformation.
NEVERuseengine or carburetor cleaner products in the fuel
tank as permanent damage may occur.
Tabla de contenido
