Telstar TRX596310MD Manual De Instrucciones página 30

Automatic Refrigerator
TRX596310MD
Do connect grounding wire! The grounding pole of the socket shall be provided with a reliable grounding wire.
Open the refrigerator body and take out the accessory (decorative cover for bottom beam) and the three
screws from the instruction packaging bag; then install them into the bottom beam as shown by the schemat-
ic diagram on the right.
The decorative cover for bottom beam is used as ornament, so you can choose not to install it. It won't affect
the refrigerator's performance or conditions no matter whether you install it or not.
• Transport and Placing of Your Refrigerator
Transport
Keep upright and avoid squeezing or vibration during transport. Avoid a slant angle over 45 degree during
handling.
Avoid the door or top cap from being under excessive stress when moving; otherwise, it may become de-
formed.
Placing
Place your refrigerator in a well- ventilated place and keep it from heat source and direct sunlight. Don't
place it in any humid or wet place so as to avoid rust and weakening of insulation effect.
There shall be a space not less than 30cm from the top of your refrigerator and not less than 10cm from both
sides or the back of the refrigerator to the adjacent walls respectively. This requirement is good for open and
close of the door and also for heat emission.
The refrigerator shall be placed on a flat and firm ground (if not flat, you can use the leveling legs for adjust-
ment).
Keep Your Refrigerator Standing
Don't connect your refrigerator to the power supply immediately after it is placed vertically. You should keep
30