Top View - American Standard A8007D-FCO Instrucciones De Instalación

(965mm)
1
Ensure that the floor and stud walls are square and plumb on a
level floor as shown in Figure A. Provide a 5" x 5" (127 x127mm)
opening in the floor for the drain and refer to the product rough-in
for actual drain location. Draw a line 2-1/8" (54mm) above the
level subfloor on the wall studs at each side of the opening.
MARK STUDS 2-1/8" (54mm)
ABOVE LEVEL SUBFLOOR
90°
2" (51mm)
PVC Waste Pipe
(See Product Rough-In for Drain Location)
FIGURE A
19"
CO
(483mm)
18-1/2"
(470mm)
38"
1"
(25mm)
1-1/8"
(29mm)
90°
Opening 5" x 5"
C/L
(127 x127mm)
A8009D-FCO
38"
(965mm)
3-3/8"
(86mm)
FRONT

TOP VIEW

13/16" (21mm)
THRESHOLD DEPTH
3/16" (5mm)
BELOW THRESHOLD
RIGHT SIDE
2
All of the shower bases require purchasing a round shower
strainer type drain for use with a standard 2" (51mm) plastic
schedule 40 waste pipe. Figure B shows the typical drain
assembly. Before installing drain into the shower base, remove
strainer. (Fig B) This will be installed after shower base is in its
final position. Cut the waste pipe height so that the drain body
will fit snug in the shower base. Apply silicone sealant between
the drain body and shower base.
NOTE: Drain not included and must be purchased separately.
DRAIN ASSEMBLY
Rubber
Caulking
Gasket
Drain
Body
Silicone
Sealant
Rubber
Gasket
FIGURE B
2
Strainer
Shower
Base
Fiber
Gasket
Locking
Nut
755472-100