STA-RITE EC6 Serie Manual De Instalación, Operación Y Repuestos página 5

2. Reinstall motor and shaft to seal plate using the four
through bolts removed in step 10 under "Disassembly".
NOTICE: Do not overtighten through bolts!
3. Slide new rotating half of seal onto shaft (Figure 2).
NOTICE: Do not nick or scratch the silicon carbide seal
face when passing it over shaft shoulder. Seal faces must
be clean and undamaged or seal may leak.
Slide ceramic
part onto
shaft.
Figure 2
4. Reassemble impeller, washer, and impeller nut.
5. Install new capacitor. See below for electrical connec-
tions to capacitor.
6. Inspect O-Ring carefully; replace if damaged. If it is not
nicked or scratched, clean and reinstall.
NOTICE: It is good practice to replace O-Ring each time
pump is serviced.
7. Reinstall capacitor cover, feeding wire through connector
hole, then reconnect cord wires to connector. Reference
color code markings.
WARNING
Risk of electrical shock.
Can burn or kill.
Do not lift pump by
power cord.
CORD LIFT WARNING
8. Fill motor with clean dielectric oil (Part No. U197-8A). To
allow room for expansion, oil level with cold motor should
be about 1/4'' (6 mm) above top of motor assembly.
Capacitor Connections (Single Phase Only)
Green
Black
Capacitor
Red
White
Black
Leads from
Stator
For three phase wiring connections, see the "Three Phase
Wiring Connection" diagrams on Page 8.
1. Attempting to lift or support pump by
power cord can damage cord and cord
connections.
2. Cord may pull apart, exposing bare wires
with possibility of fire or electrical shock.
3. Lifting or supporting pump by power cord
will void warranty.
4. Use lifting ring or handle on top of pump
for all lifting/lowering of pump. Disconnect
power to pump before doing any work on
pump or attempting to remove pump from
sump.
5
Green
White
Red Black
Green
White
Red
Black
Motor leads
HT7 only
1308 1094