Application; Choosing Nozzle Type; Disposal Of Waste Products; Information Needed By User - Jacto pjh Manual Del Operador

internal walls.
5. Take the container cap off and carefully pour the rinse water into the spray
tank.
6. Keep holding the container over the spray tank opening for approximate-
ly 30 seconds to the last drop.
7. Repeat this operation twice more. This way, you complete the triple rinse.
8. Make the plastic and metallic containers useless by piercing the container
bottom with a pointed instrument. This way, their labels are not damaged
for identification purposes.

4.4. Application

Wear appropriate protective clothing
Do not contaminate water
Spray downwind and
avoid drift

4.5. Choosing nozzle type

Seven main nozzle designs are used on knapsack sprayers. Each nozzle design
is available in a range of sizes to optimize the use of product to be applied. The
nozzle choice will be based on the agrochemical type to be used and the droplet
size recommended (table):
NOTE: The following nozzles are optional, so they do not accompany this sprayer.
10/19
Keep constant height
IDENTIFICATION
NOZZLE
FILTER (Mesh)
(Part no. - Description)
TYPE
(1197535) JEF 110015
80 (Zinc yellow)
(1197536) JEF 11002
50(Gentian blue)
YELLOW
(1197537) JEF 11003
50(Gentian blue)
(1197475) JSF 110015
80 (Zinc yellow)
(1197476) JSF 11002
50(Gentian blue)
YELLOW
(1197477) JSF 11003
50(Gentian blue)
(1197565) JHC 8002
50(Gentian blue)
(1198892) JHC 8004
50(Gentian blue)
(1198893) JHC 8005
50(Gentian blue)
(1197486) JDF 04
50(Gentian blue)
(1197487) JDF 05
50(Gentian blue)
(1197488) JDF 06
50(Gentian blue)
(1197497) JAI 120015
80 (Zinc yellow)
(1197499) JAI 12002
80 (Zinc yellow)
(1197501) JAI 12003
50(Gentian blue)

4.6. Disposal of waste products

The elimination of waste resulting from the dismantling of equipment during ser-
vice, maintenance or end of life (disposal) should be carried out respecting the
environment, preventing pollution of air, soil and water. If necessary, the waste
should be stored in appropriate locations and then transported by qualified and
trained people and companies.
Disposal of used sprayer should be done at appropriate points and approved for
receiving such material. If there isn't an appropriate nearby site, please contact the
Customer attendance: Dr. Luiz Miranda, 1650, 17580-000 – Pompeia – SP – Brazil.
Phone: +55 14 3405 2113. Email: [email protected]
Opening Hours: Monday to Friday 7:00am to 11:30am and 13:00pm to 17:18pm
(Brazilian time zone).

5. Information Needed by User

5.1. Troubleshooting

• Put about 2 liters of water in the tank.
• While operating the lever, look into the tank to see how the problem arises.
• Refer to the table and diagram below.
DESCRIPTION
Leakage through the
cylinder upper part.
After pumping and
pressurizing the chamber,
not sealing properly
as you operate the lever it
due to wear or impurities.
drops fast.
After pumping and
pressurizing the chamber,
not sealing properly
the lever rises quickly when
due to wear or impurities.
released.
PRESSURE
APPLICATION
(psi)
30
GREEN
Fungicide,
insecticide
and 30
foliar
fertilizers
30
BLUE
30
GREEN
Fungicide,
insecticide
30
and
foliar
fertilizers
30
BLUE
45
YELLOW
Fungicide,
insecticide
45
RED
and
foliar
fertilizers
45
BROWN
15
RED
Herbicides
and
15
BROWN
foliar
fertilizers
15
GREY
20
GREEN
Herbicides
20
YELLOW
20
BLUE
CAUSES CORRECTIONS
Worn or dried out Replace or lubricate
piston cup. the pump.
Cylinder valve
Clean or replace
the valve.
Chamber valve
Clean or replace
the valve.
FLOW RATE
(l/min)
0.49
0.65
0.98
0.49
0.65
0.58
0.80
1.60
2.00
0.92
1.15
1.39
0.42
0.57
0.85