Wall Control Installation - Home Decorators Collection ALTURA Guía De Uso Y Cuidado

Operating Your Fan and Wall Control
Wall Control - Your fan is equipped with a wall control to operate the
speed of your new ceiling fan. For more information on how to
install the wall control, see the wall control instructions packaged
with the wall control components.
The appropriate speed setting for warm or cool weather depends on
factors such as the room size, ceiling height, and number of fans.
The fan is shipped from the factory with the reversing switch
positioned to circulate air downward. If air flow is desired in the
opposite direction, turn your fan off, and wait for the blades to stop
turning, then slide the reversing switch (located in the switch cup) to
the opposite position, and turn the fan on again. The fan blades will
turn in the opposite direction and reverse airflow.
NOTE: Wait for the fan to stop before reversing the direction of blade
rotation.
Warm weather - (Forward) A downward airflow creates a cooling
effect. This allows you to set your air conditioner on a higher setting
without affecting your comfort.
Cool weather - (Reverse) An upward airflow moves warm air off of the
ceiling. This allows you to set your heating unit on a lower setting
without affecting your comfort.

Wall control installation

WARNING: To avoid possible electrical shock, be sure
electricity is turned off at the main fuse or circuit breaker
box before wiring. Turning off the wall switch is not sufficient
to prevent shock. All wiring must be in accordance with
National and Local codes, and the ceiling fan must be properly
grounded as a precaution against possible electrical shock.
NOTE: This control is designed to operate only one ceiling
fan.
□
Disconnect the power at the circuit breaker (fuse) box.
□
Set the wall mounted control switch to 0.
□
Remove the existing wall plate and switch.
□
Connect the Green / Yellow wire from the wall mounted control
switch to the green or bare wires in the junction box, secure with a
plastic wire connector.
□
Connect the household white wire to the white wire to the ceiling
fan, secure with a plastic wire connector.
□
Connect the household black wire to the black wire marked "AC IN
L", secure with a plastic wire connector.
□
Connect the black wire marked "TO MOTOR L" to the black wire to
the ceiling fan. Secure with a plastic wire connector.
□
Wrap each wire connector with electrical tape (not included).
□
Separate the black wires to from the white and green wires. Turn
the green and white wires into the junction box.
□
Turn the black wires into the junction box.
□
Secure the wall mounted control to the outlet box with the two
screws provided.
□
Gently press the face plate on to the wall control (it will snap into
place).
□
Restore power at the circuit breaker (fuse) box, your fan should
now be operational with the wall mounted control switch.
BLACK (TO MOTOR L) TO
BLACK (CEILIING FAN SUPPLY)
GREEN/YELLOW
TO HOUSEHOLD
GREEN / BARE
3
2
1
0
BLACK (TO AC IN L) TO
HOUSEHOLD BLACK
13
Please contact 1-800-986-3460 for further assistance.
CEILING FAN
SUPPLY WIRES
GREEN or
BARE
HOUSEHOLD
WHITE TO
WHITE (CEILIING
FAN SUPPLY)
HOUSEHOLD
WIRING
HOMEDEPOT.COM/HOMEDECORATORS