Product Overview - Panasonic CS-MC12DKU Instrucciones De Operación

Note: The illustrations in this manual are for explanation purposes only and may differ from the
actual unit. It is subject to change without notice for future improvement.

PRODUCT OVERVIEW

Indoor Unit
Front panel
Air filter
Airflow direction
louver
Discharged air
Outdoor Unit
Air inlet
Air inlet
(side)
Remote Control
LCD display
Operation mode
Powerful operation
Quiet operation
Timer setting
Clock setting
Troubleshooting
Operation delayed for a few minutes after restart.
●
Sound like water flowing during operation.
●
Mist emerges from indoor unit.
●
Noisy during operations.
●
Remote control/display does not work.
●
The unit cannot operate.
●
Outdoor unit emits water/steam.
●
(rear)
Air outlet
Transmitter
Memory reset
Air intake
Air Purifying filter
Auto OFF/ON
button
Receiver
Indicator
Off/On
Economy operation
Temperature setting
Fan speed selection
Airflow direction
adjustment
This is a normal self protection function.
➤
Caused by refrigerant flow inside.
➤
Condensation effect due to cooling process.
➤
Installation work could be slanted or front panel isn't closed properly.
➤
Check whether batteries are correctly inserted or need replacement.
➤
Check whether circuit breaker is tripped or timer is being used correctly.
➤
Condensation or evaporation has occurred at piping surface.
➤
■ About
Remote Control Preparation
1. Pull out
2. Insert batteries
(AAA or R03)
3. Press CLOCK button
4. Set
current
time
5. Press again to confirm
• Timer operation will be based on current
time set.
• The batteries can be used for
approximately 1 year.
• The batteries must be recycled or
disposed of properly.
Remote Control Signal
• Make sure it is not obstructed.
• Maximum distances : 32.8 ft (10 m).
• Certain fluorescent lights may interfere
with signal transmission. Consult your
dealer.
Auto OFF/ON Button
• To operate the unit if the remote
control is misplaced or malfunctioning.
Operation
Action
mode
Automatic
Press once
Operation
Press until "beep" Cooling
sound Operation
• To turn OFF, press the Auto OFF/ON
button again.
• To switch the remote control signal
receiving sound off or on.
1. Press until you hear a "beep" sound
and release.
2. Press again until you hear a "beep-
beep" sound and release.
3. Press to switch the sound off or on.
(Long "beep" - OFF; short "beep"
- ON)
3