Assembly And Use - Sienna Visio SSC-1001 Manual De Instrucciones

Connecting 8 inch or 11 inch squeegees:
1) Insert squeegee to steam nozzle and align tabs. Press fi rmly together. Press button
on steamer body just below the squeegee to release attachment.
Connecting jet nozzle to steam nozzle:
2) Begin by aligning the jet nozzle with the tab located on the steam nozzle. Firmly
press the two pieces together until you hear a click. Press button on steamer body just
below the nozzle to release attachment.
Connecting angle concentrator nozzle and round brush:
3) Begin by aligning hexagonal shaped hole on back of the angle concentrator nozzle
and/or round brush with hexagonal tip of the steam nozzle and press fi rmly. To remove
round brush, make sure the unit is unplugged and has cooled down. Firmly pull on
brush until it detaches itself from the nozzle head.
IMPORTANT: Make sure the accessory is pushed as far as possible onto tip to ensure
the fi t is sealed. This will prevent steam from seeping out unwanted areas and prevent
injury.
NOTE: The steamer does not require distilled water. Residents in areas with hard water
should use distilled water for better performance.

ASSEMBLY AND USE

1
2
3
6