GYS TIG 168DC Manual Del Usuario página 12

Cold current setting (low intensity) (from 20 to 70% of hot current)
Selected as a percentage of hot current : the colder the current, the cooler the welding piece will stay
during the welding process.
Down slope setting (0 to 10 sec)
Time needed to shift from welding current to minimum current. Avoids cracks and craters at the end of
welding.
Post-gas setting (3 to 20 sec)
This parameter determines the length of time in which gas is released after the arc has stopped. It
protects the weld pool and the electrode against oxidization whilst the metal is cooling after welding.
Advice : Increase the time if the welding appears dark.
(For default setting : 25A=4sec. – 50A=8sec. – 75A=9sec. – 100A=10sec. – 125A=11sec. –
150A=13sec.
n.b. : You can check your settings at any time by pressing the parameter button, without turning the wheel.
Functions available according to welding mode
According to welding mode selected, some buttons will not work, please see table below :
Starting
HF

Normal TIG

Pulse TIG

Easy Pulse TIG

SPOT
Memory settings: saving and recall
There are 5 memory slots to save and recall TIG parameters. As well as these, the 168/200 stores the last used
settings, and activates them when the machine is restarted.
- 200A=15sec-250A=25sec).
Trigger
TIG Lift 2T 4T 4T log
   
  
  

Input
and hold for 1 second until "In" is displayed.
As long as the display indicates "In", the action can be cancelled.
2- After one second, the display indicates a program number (P1 to P5),
keeping the button pressed, turn the wheel to select the desired memory
location. Release the button to store the parameters.
Recall a set-up
Proceed as above by pressing the
Reset factory parameters
3 seconds.
2- The display indicates "Ini".
All saved memory settings have been deleted (the factory parameters are set
on all 5 programs + start parameters).
TIG process
Pre-gas

 
(I)

 
(I)

 
(average I)
 
1-
button
1-
Post-gas

(only in
 
4T log)
   
 

Press the
Press the reset button for
button
12/40