Electrolux Eureka 2940 Serie Guia Del Propietario página 14

Edge Kleen™ model shown (some models only)
Modèle Edge Kleen™ illustré (certains modèles seulement)
Se muestra el modelo Edge Kleen™ (sólo algunos modelos)
Edge Kleen™ model shown
(some models only)
Modèle Edge Kleen™ illustré
(certains modèles seulement)
Se muestra el modelo
Edge Kleen™ (sólo algunos
modelos)
Edge Kleen™ model shown
(some models only)
Modèle Edge Kleen™
illustré (certains
modèles seulement)
Se muestra el modelo
Edge Kleen™
(sólo algunos
modelos)
Edge Kleen™ model shown
(some models only)
Modèle Edge Kleen™ illustré
(certains modèles seulement)
Se muestra el modelo
Edge Kleen™
(sólo algunos modelos)
14
ENGLISH
PERIODIC MAINTENANCE
How To Replace Brushroll Belt
Step 1: Lower handle to floor to change belt (FIG. 22).
Step 2: Remove the two screws from the top of the hood (FIG. 23).
Step 3: Lift hood to remove (FIG. 24).
Step 4: Lift right end of brushroll (FIG. 25).
Step 5: Remove and discard belt.
Step 6: Place new belt around motor shaft.
FIG. 22
Step 7: Place new belt around brushroll pulley.
Step 8: Align left end cap with base. Push end cap securely into place.
Make sure the square on the brushroll cap is in place (FIG. 26).
Step 9: Pull right side of brushroll to stretch belt. Secure right end cap
into base.
IMPORTANT
Step 10: Rotate brushroll by hand 2 full rotations to properly
position belt.
Step 11: Place hood back on cleaner. Replace and tighten two screws.
Step 12: Return vacuum to upright position.
FIG. 23
FIG. 24
FIG. 25
FIG. 26
(CONTINUED)
(continued)