Parts And Functions - Haier HSM07HEK03/R2 Manual Del Usuario

Parts and Functions

Indoor Unit
1
2
3
Inlet
1
2 Inlet grille
Outlet
3
4 Vertical blade
(adjust left and right air flow)
5 Horizontal flap
(adjust up and down air flow.
Don't adjust it manually)
Please be subject to the actual produce purchased the
above picture is just from your reference
Outdoor Unit
OUTLET
CONNECTING PIPING AND ELECTRICAL WIRING
DRAIN HOSE
INLET
Please be subject to the actual produce purchased the
above picture is just from your reference
Clock set
Press CLOCK button, "AM" or "PM" flashes.
Press or to set correct time. Each press
or decrease 1min. If the button is kept pressed,time will
change quickly. After time setting is confirmed,press SET,
"AM "and "PM" stop flashing,while clock starts working.
2
8
6
4
7
5
6
Display board
Emergency Switch
7
Air Purifying Filter
8
(inside)
4
will increase
POWER/SOFT
TIMER
CLOCK
LIGHT
SET SLEEP
LOCK RESET
Remote controller
10
1
6
2
7
8
5
9
3
4
ON/OFF
11
13
FAN
18
MODE
15
SWING
POWER/SOFT
23
T MER
12
20
CLOCK
21 14
L GHT
19
16
SET SLEEP
17
22
LOCK RESET
1. Mode display
Operation mode
AUTO COOL DRY HEAT FAN
Remote controller
2. SWING display
3. FAN SPEED display
AUTO LO MED HI
4. SLEEP display
5. LOCK display
6. SIGNAL SENDING
7. TIMER OFF display
8. TIMER ON display
Loading of the battery
4
Load the battery,then put on the cover again.
Note:
The distance between the signal transmission head and the rece
iver hole should be within 7m without any obstacle as well.
When electronic sta rted type fluorescent lamp or change over
wireless telephone is installed in the
type fluorescent lamp or
room, the recei ver is apt to be disturbed in receiving the signals,
so the distance to the indoor unit should be shorter.
Full display or unclear display during operation indicates the
batte ries have been used up. Please change batteries.
If the remote controller can't run normally during operation, please
remove the batteries and reload several minutes later.
Hint:
Remove the batteries in case won't be in use for a long period. If
there is any display after taking out, just press reset key.
9. CLOCK display
10.TEMP display
11. POWER ON/OFF button
12. MODE button
13. FAN button
14. HOUR button
15. SWING button
16. SLEEP button
17. LOCK button
Used to lock buttons and LCD
display.
18. TEMP.SETTIN button
19. SET / LIGHT button
20. TIMER button
21. CLOCK button
Used to set correct time.
22. RESET button
When the remote controller
appears abnormal, use a sharp
pointed article to press this
button to reset the remote
controller normal.
23. HOUR / POWER/SOFT button
Used to set clock and timer setting.
Every time the button is pressed,
display changes as follows:
BLANK
POWER SOFT
1
Remove the battery cover;
2
Load the batteries as illustrated.
2 R-03 batteries, resetting key
(cylinder);
3
Be sure that the loading
e" + "/"-";
is in line with th