Complete Installation Checklist; All Models; Electric Models; Gas Models - Kenmore W10850308A Instrucciones De Instalación

COMPLETE INSTALLATION
CHECKLIST
Check that all parts are now installed. If there is an extra
■
part, go back through steps to see what was skipped.
Check that you have all of your tools.
■
Dispose of/recycle all packaging materials.
■
Check dryer's final location. Be sure vent is not crushed
■
or kinked.
Check that dryer is level. See "Level Dryer."
■
Remove film on console and any tape remaining on dryer.
■
Wipe dryer drum interior thoroughly with a damp cloth to
■
remove any dust.
Read "Dryer Use" in your "Use and Care Guide."
■

All Models:

Select a Timed Dry heated cycle, and start dryer.
■
Do not select Air Only Temperature setting.
If dryer will not start, check the following:
• Controls are set in a running or "On" position.
• Start button has been touched and held for 3 seconds.
• Dryer is plugged into an outlet and/or electrical supply
is connected.
• Household fuse is intact and tight, or circuit breaker has
not tripped.
• Dryer door is closed.

Electric Models:

For power supply cord installation, plug into a grounded
■
outlet. For direct wire installation, turn on power.
When the dryer has been running for 5 minutes, open the dryer
■
door and feel for heat. If you feel heat, cancel the cycle and
close the door.
If you do not feel heat, turn the dryer off and check
the following:
• There may be 2 household fuses or circuit breakers for the
dryer. Check that both fuses are intact and tight, or that
both circuit breakers have not tripped. If there is still no
heat, contact a qualified technician.

Gas Models:

Check that gas supply is on.
■
Check for leaks.
■
When the dryer has been running for 5 minutes, open the dryer
■
door and feel for heat. If you feel heat, cancel the cycle and
close the door.
If you do not feel heat, turn the dryer off and check to see
whether gas supply line shut-off valve is open.
• If the gas supply shut-off valve is closed, open it,
then repeat the 5-minute test as outlined above.
• If the gas supply shut-off valve is open, contact a qualified
technician.
All Models:
NOTE: You may notice an odor when dryer is first heated. This
odor is common when heating element is first used. The odor will
go away.
21