Honeywell HW7500E Manual Del Propietário página 15

Step 3: Install Handle Assembly
To install handle assembly, you will need:
‰ Handle pivot brackets (2)
‰ Handle bars (2)
‰ Pin and chain (2)
‰ Rubber handle grips (2)
‰ M6 X 40 mm long hex flange bolts (6)
‰ M6 serrated flange nuts (6)
‰ Socket wrench with 8 mm socket
‰ 10 mm open end wrench*
* Not included
Hold handle pivot bracket over pre-drilled holes on
1.
frame as shown in Figure 11.
FIGURE 11: Handle Bracket to Frame
2. Attach bracket to frame using 40 mm long hex flange
bolts and serrated flange nuts and tighten.
3. Slide handle bar through center of each bracket and
line up bolt holes.
FIGURE 12: Insert Handle Bar to Bracket
Attach handle to each bracket using 40 mm long
4.
flange-head hex bolt and serrated flange nut to hole closest to frame and tighten.
NOTE:
Handle should be in a horizontal position after tightening
bolts and nuts. If handle seems to hang down, tighten
bolts and nuts further.
HW7500E/HW7500EL Portable Electrical Generator Owner's Manual
5.
*
6.
Once properly installed, the handles can be collapsed, if
desired, by removing the pins.
• Keep hands and fingers clear from hinges when
• Handles should only be used to roll the generator to a
•
•
Attach chain to handle bracket as illustrated below.
Insert pin through bracket and handle.
FIGURE 13: Attach Chain to Handle Bracket
Slide rubber handle grip onto each handle bar and
push to achieve snug fit.
FIGURE 14: Attach Grips to Handle
CAUTION
Hands and fingers can be pinched from collapsible
handles.
collapsing generator handles.
new location. If lifting the generator (i.e. into a vehicle),
never use the handles to support the complete weight
of the generator.
To collapse handles, remove pins and push firmly
down on handle until it rests vertically against genera-
tor frame.
To return handles to horizontal position, pull up on
handle and lock with pins.
www.honeywellgenerators.com
Assembly
9