Location Selection - Zoeller QWIK JON ULTIMA 202 Instrucciones De Instalación

Qwik Jon Ultima Qwik Reference Guide
®
STEP 1

Location Selection

Plan your new installation carefully.
Floor: The floor should be structurally sound and
level within 1/8" (3 mm). If the floor is not level,
use hydraulic cement or similar material to level
the floor.
Water: A water supply will be needed to operate
the toilet. Usually a 1/2" (DN15) line with a shut-off
valve is sufficient.
Electrical: A 115 volt GFCI or RCD receptacle will
be needed to supply electrical power to the pump.
Sewage: Access to a sewage line is required. The
Qwik Jon Ultima requires a 1" (DN25) [or 3/4"
®
(DN20) if your codes permit] sewage discharge
line to connect to an existing sewage line. A ball or
gate valve should be installed in the discharge line.
Vent: Access to a vent pipe is required. The use of
a mechanical vent system is NOT recommended
as the toilet will not flush.
NOTE: If a built-in installation is to be used, locate
the pump unit in an area that will allow access to
the pump and switch.
STEP 2 Leveling of Pump Unit
Do not use wooden shims to level the pump unit!
CAUTION
Ensure that nails, screws or other sharp objects do not
CAUTION
puncture the pump unit!
Level the pump unit to within 1/8" (3 mm) using hydraulic cement or
similar material.
© Copyright 2019 Zoeller
VENT
DISCHARGE
PIPE
PIPE
BALL OR GATE VALVE
SOLD SEPARATELY.
GFCI
OUTLET
WATER
SUPPLY
LEVEL FLOOR
Co. All rights reserved.
®
6
STEP 3
NOTES:
a) Do not use pipe dope on any plastic or rubber parts.
b) Be careful when tightening bolts or nuts against china to avoid
cracking the china.
Item Description
1 Toilet tank cover
2 Toilet tank
3 Toilet tank to toilet bowl gasket bolts
4 Rubber toilet tank to toilet bowl gasket
5 Water supply connection
6 Water supply line rubber seal
7 Water supply line adapter
8 Water supply line (not included)
9 Plastic flat washer
10 Plastic nut
11 Bolt cover
12 Toilet bowl
WATER SUPPLY HOOK-UP DETAIL
SK2588
RUBBER WASHER
PLASTIC COUPLING
WING NUT
WATER SUPPLY
DO NOT OVERTIGHTEN. Ballcock shank may
CAUTION
split and void the warranty.
SK2589
Toilet Assembly
5
6
7
8
9
10
BALLCOCK
TOILET TANK
RUBBER SEAL
PLASTIC WASHER
PLASTIC WASHER
PLASTIC NUT
Set the black rubber washer.
Push down on the top of the tank one side at a time to tighten
the nuts under the bowl. Alternate tightening nuts making sure
bowl is level.
DO NOT OVERTIGHTEN or china may crack.
CAUTION
© Copyright 2019 Zoeller Co. All rights reserved.
®
7
1
2
3
4
11
SK2593
TANK TO BOWL DETAIL
PLASTIC BOLT
RUBBER WASHER
TOILET TANK
TOILET BOWL
SK2594