Installation - Jacuzzi DESIGNER Serie Instalación, Uso, Mantenimiento

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 36
5
6
7

Installation

u (
1) Using 3/4" flexible hoses (L=500 mm), connect the
floor outlets on the floor to the filters (FL); then connect the
filters to the thermostatic tap by means of the 3/4" flexible hoses
(L=1000 mm).
Arrange the filters vertically, as shown in the figure for
perfect filtering (the control levers L must be facing upwards).
u (
2) Insert the fitting (A) in the hole shown and arrange a
gasket in between.
EV2
Then insert the display cable (D) in the specific hole.
Position the tap body so that it is inserted on the shower
support (F).
Fix the fitting (A) from underneath, as shown, and position the
other gasket in contact with the surface of the tub.
Do not tighten the ring nut and screws at this time.
u (
3) Screw the flexible hose to the hand shower and
arrange the specific gasket in between.
u Cut the clamp securing the shower flexible hose to the
tub and position the hose under the tub. Check that it runs
smoothly.
u (
4) Finally fix the tap body.
u (
5) Connect the flexible hose (from the thermostatic tap
solenoid valve, EV2) to the tub filler body.
Finally connect the yellow-green cable (from the ground terminal
on the tub frame) to the faston connector on the indicated
washer.
u Refer to the wiring diagrams attached to the tub to connect
the electrical wiring box of the tub to the network of the
building.
In models without hydromassage, arrange a two-pole cable
(2 x 1 mm
2
) to connect to the cable leading from the electrical wiring
box to the tap.
u (
6) Connect the cable from the tap display (D) to the tap
electrical wiring box connector (the electrical wiring box is fixed
to one of the legs of the frame).
(
7)
1: power cable from tub electrical wiring box (220-240 V)
2: level probe cable
3: display cable
4: thermostatic tap motor cable + temperature sensor
5: solenoid valve cable
u Proceed by installing the tub as shown in the corresponding
manual.
u Check that the column control, after closing the drain, is
positioned as shown in the figure:
13
13
OK
NO!
Tabla de contenido
loading

Tabla de contenido