Repeat Function - alfatest Multijet Pro Manual Del Usuario

MULTIJET PRO

8.0 - REPEAT FUNCTION

The aim of this function is to optimize repetition of the last test conducted, allowing comparison between tests without
resetting.
When used, the verification and setting stages are eliminated.
Whenever the icon is disabled and there is no paused or on going test, the Pressure/Repeat key will
have the REPEAT function.
This function will be very productive when the aim is to compare two test cycles from the same injector assembly.
USE OF THIS FEATURE WILL ONLY BE EFFECTIVE IF DONE IMMEDIATELY AFTER THE TEST TO BE
COMPARED AND WITHOUT ANY RESETTING (PRESSURE, ETC.)
Conduction:
1) Before conducting any other test, press REPEAT key , the display will display the number of the last test
conducted.
The 'connection safety alert' icon will blink in the panel, ensure that the hose connectors are connected and
locked. (This occurs in all injectors tests as a form of prevention).
2) Press the Start/Cont. and keep it pressed until there is a continuous "beep", allowing activation of the pump
and setting of the pressure
While activated, the Multijet PRO keeps the last pressure setting. In the beggining of the test, the initial
pressure will be the last pressure setting, wait for automatic set and proceed the manual set if necessary.
3) If necessary, after icon comes on, set the pressure pressing the pressure set keys .
The pressure can be adjusted by touch or keeping them pressed (continuous adjustment).
The adjust procedure and security warnings are the same performed in previous tests.
4) Press Start/Cont. key to Start the test.
The display will indicate the start of the test with the letter "t".
During the test, the injectors frequency will be displayed (RPM - Rotacion per minute).
If the "10x" icon comes on, the user must multiply the number displayed by 10
If necessary, the pressure can be adjusted during the test by the keys .
A "beep" will occur at the end of test.
If necessary, drain the test fluid from the test tubes by the Drain key . If the Drain is not manually turned off f
after drainage, will turn it off automatically after 1 minute. The icon indicates Drain active.
The Repeat Function can be conducted as many times as are required.
37