Velleman CAMIP12N Guía Rápida página 5

7.2 Preparing the network configuration
1. Connect your camera to your wireless router using the included RJ45 network cable (see Network
setup above).
2. Write down the IP address of your wireless router. You will need it later. To find the IP address,
proceed as follows:
7.3 Adding your camera to the EagleEyes app
1. Establish a wireless connection between your mobile device and the wireless router that has the
camera connected.
2. Open the EagleEyes app and click the "+" button to add a new device.
3. Select "Local Network Search" to search for the camera.
4. Select the camera from the list. The settings page appears.
5. Change the port number of the camera as needed. The default port number is 88. If port number 88
is blocked, you can change it to any value from 1~9999 (for example 8080).
6. Write down the IP address and the port number of the camera. You will need them later.
(In the sample screens below [A], the IP address is 192.168.2.197 and the port number is 88.)
7. Press "Apply" to confirm your settings.
8. Wait until "Status" [B] indicates "Done" or "Fail".
If the status shows "Done", the device page appears again. Proceed with the next step.
o
If the status shows "Fail", press the
o
popup window, select "DDNS". The device page appears again. Proceed with the next step.
V. 02 – 01/03/2017
CAMIP12N
3. Connect your mobile device to the wireless
router that has the camera connected.
4. Go to Settings > WiFi.
5. Press the ">" button to see the details of the
selected wireless network.
The IP address is visible next to "Router".
(In the sample screen, the IP address is
192.168.2.1)
The device will show a list of devices on the network.
The displayed IP address is the address that your
router assigned to your camera.
If the camera is not in the list, make sure the LAN
status indicator
Reset the camera with the Reset button if necessary.
Wait for 3 minutes and then use "Local Network
Search" again.
button on the top right side of your device. In the
5
on the camera is on (not blinking).
©Velleman nv