Black+Decker HH2455 Manual De Instrucciones página 5

aSSeMbly ToolS reQUireD (noT SUPPlieD):
- Phillips Screwdriver
aTTacHinG bail HanDle To TriMMer
warninG:
trimmer. The use of the hedge trimmer
without the proper guard or handle
provided may result in serious personal
injury.
The trimmer is shipped with the bail handle
tied to the trimmer. To attach the bail handle:
• Cut the zip tie which holds the handle to the
trimmer.
• Remove the phillips head screws from both
sides of the trimmer housing.
• Position the handle in place as shown in
figure a.
• Reinsert the phillips head screws into the openings on the side of the handle and
tighten securely.
aTTacHinG exTenSion corD To TriMMer
An extension cord retainer is built into
the switch handle that helps prevent the tool from coming unplugged. To use this
feature, first overlap the pigtail cord with the extension cord and tie the two cords in a
knot as shown in figure b. Then, double the extension cord several inches from the
end, and hook the loop formed by doubling the cord over the post in the opening in the
back of the handle area as shown in figure c. Gently tug on the cord to insure that it is
firmly retained in the trimmer's handle.
Save THeSe inSTrUcTionS for fUTUre USe
To TUrn THe Tool on
Pull the LOCk BUTTON (4) back with
your thumb and then squeeze the
TRIGGER (5) with your fingers as
shown in figure D. (Once the tool is
running you can release the LOCk
BUTTON.) To turn the tool OFF, release
the TRIGGER.
aSSeMbly inSTrUcTionS
only use with handle and guard properly assembled to hedge
b
oPeraTinG inSTrUcTionS
a
c
D
5
5
4