Idiomas disponibles
Idiomas disponibles
Rotisserie Kit Assembly (Rotisserie motor on left side as shown)
Remove warming
rack
from
firebox,
insert
motor
support
into
motor
support
bracket
preassembled to left side of firebox (A).
[]
insert rotisserie motor onto motor support (B). Make sure to insert motor with power cord at
bottom.
[]
Slide the shaft collar onto the rotisserie rod followed by the two forks (forks should be
pointing toward
each other). Make sure that shaft collar is positioned near rounded end of
rotisserie rod. Tighten Wing Screw, Flat Head Set Screw on shaft collar and forks, but do not fully
tighten in this step. (C)
[]
insert the pointed end of the rotisserie rod into the hole for it in the motor. On the other end of the
rod, slide the shaft collar to the point where the groove in the collar will lay securely in the slot in
the firebox wall
(D). Fully tighten the collar Wing Screw, Flat Head Set Screw with slotted
screwdriver.
[]
The rotisserie motor can be assembled on either the left and right side of firebox, if you need to
use the rotisserie and side burner at the same time, you may position the motor over the searing
burner side of the grill. Remove motor, motor support and motor support bracket and reassemble
to the other side of firebox. To detach bracket, remove the two screws and use them to attach the
bracket to the other side.
C
A
D
34 " 146.03358410
