Tapered Shaft Encoder - Kübler Sendix 58 FS2 Serie Manual De Instrucciones

Flange with rigid torque stop
SW 3
Check the threaded rod regularly
Under high loads, the threaded rod of the torque stop can be
subject to a certain wear (e.g. in case of high rotational
speeds with reversing operation).
• Depending on the range of application, check the threaded
rod regularly.
• In the event of wear, immediately replace the threaded rod
and the torque stop.
• Comply with the maximum permissible shaft offset.
BA Sendix® 58xxFS2 / 58xxFS3 - R60049.0009 - 05
36028797080561035
NOTICE
4.1.3.2.1 Assembly Instructions for Hollow Shaft
Encoders
a) Slide the encoder on the shaft.
b) Comply with the minimum and maximum insertion depth of
the shaft in the encoder.
c) Comply with the maximum permissible shaft offset.
d) Screw the stator coupling or the torque stop without pre-
load on the drive flange.
e) Tighten the screw on the clamping ring.
f) Secure the screws against loosening, see chapter
Screw Retention [} 53].

4.1.3.3 Tapered Shaft Encoder

Di- 5834FS
men- Incremental
sion
a 59 [2.32]
83084939
5873FS 5883FS
Singleturn Multiturn
Absolute Absolute
59 [2.32] 70,5 [2.78]
EN - 51