Emerson CARRERA CF784BS01 Manual Del Usuario página 8

3. Ceiling Fan Assembly
3.9
Turn the partially assembled ceiling fan right side up in
preparation for final assembly.
Carefully place the partially assembled ceiling fan on the
styrofoam being careful not to bend the ceiling fan blades
(Figure 9).
3.10
Remove the hanger ball from the 4.5" downrod by
loosening the setscrew in the hanger ball until the ball falls
freely down the downrod (Figure 10).
Remove the pin from the downrod, then remove the
hanger ball.
Retain the pin and hanger ball for reinstallation in
NOTE: Do not loosen the screw holding the green
Step 3.15.
ground wire.
3.11
Separate, untwist and unkink the three 80" motor leads.
Route the 80" black and white motor leads through the
4.5" downrod (Figure 11).
WARNING
!
It is critical that the clevis pin in the motor coupling is
properly installed and the setscrews securely tightened.
Failure to verify that the pin and setscrews are properly
installed could result in the fan falling.
(continued)
PARTIALLY ASSEMBLED
CEILING FAN
Figure 9
PIN
SETSCREW (LOOSENED)
Figure 10
THREE 80" MOTOR LEADS (UNTWISTED)
Figure 11
8
STYROFOAM
GREEN GROUND WIRE
4.5" DOWNROD
HANGER BALL
4.5" DOWNROD
U.L. Model No.: CF784-1