Sperian Miller Butterfly II Manual Del Usuario página 5

Refs concerned: Belts: 1011701, 1011702, 1013641, 1016681, 1016682, 1016683, 1013724,
fig . 1
fig . 4
To prevent sliding, the belt strap (red with black edging) is placed under the two tabs fitted to the automatic
buckle of the belt (male section) Fig 1.
Pull the two thicknesses of the strap out of these tabs Fig2. Close the buckle. Pull firmly and smoothly on the
strap to fit it to your waist size Fig3. After adjustment, open the buckle and put the two strap thicknesses back
under the tabs Fig4.
The excess length of strap can be slid underneath the black elastic on the male buckle end Fig5.
Refs concerned: Belts: 1011701, 1011702, 1013641, 1016681, 1016682, 1016683, 1013724,
1- To disassemble the central point: use a No 4 Allen wrench to unscrew the 2 shackles .
2- Insert the new central point in one of the shackles, ensure that it is free of any grease and
screw up to contact and tighten by a half-turn .
NB: Because the screws are already coated ("TUFLOCK" type coating) there is no need to add Loctite .
The pre-coated screws can be removed/installed up to 4 times . After that, they need to be replaced
(available spare parts) .
3- Repeat the above operations for the other side .
Automatic buckles
1013725, 1013726, 1013727, 1013728, 1013729
fig . 2
Disassembly of central point
1013725, 1013726, 1013727, 1013728, 1013729
Central points: 1011705, 1011706, 1011707, 1012232
fig . 3
fig . 5
Equipment required:
No 4 allen wrench
5