Klarstein Blanca Manual Del Usuario página 20

EN
20
ASSEMBLY
WARNING
Risk of electric shock and other injuries! Only assemble the dos device
as described in the operating instructions.
Required tools:
Pre-drill (2 mm)
Drill bit (8 mm)
Masonry drill
Phillips screwdriver
Drill
Assembly instructions
Before you begin with the assembly, please note the following points:
• 2 persons are required for assembly.
• Keep your back straight when lifting.
• Avoid turning your hips. It is better to put your feet back on.
• Avoid strong bending of your upper body. Always go to your knees instead
of bending your hips. Do not lean in front of or to one side while carrying the
fi replace.
• Always grasp with the palm of your hand. Do not use your fi ngertips to hold the
fi replace.
• Keep the chimney as close to the body as possible to avoid unnecessary and
disproportionate strain on the body.
• Use gloves for extra support.
• Ask for help if needed.
Unpacking the contents
The device is delivered in a single carton. When carefully removing the unit, observe the
following instructions:
• Make sure that the device is in the correct position, as it is mounted on the
• is printed on the carton.
• Remove the tapes cuffs.
• Carefully lift the chimney out of the carton.
• Remove the transport protection and the foils from the fi replace.