Brief Operating Instructions; Brief Operating Instruction For Sas Super Iaq; Installation; Practical Use Of Contact Plates - VWR SAS Super IAQ Manual Del Usuario

Brief operating instructions

Brief operating instruction for SAS Super IAQ

1. Press main switch.
2. Press 'START' button to sample the same air volume as the last sampling cycle.
3. To change the air volume, use the arrow buttons and select 'USER MODE' from the menu.
4. Refer to the instruction manual to change settings.
5. Press 'ENTER' to confirm selection.
6. Press arrows for menu selection to modify other pre-set parameters.
7. Press 'ENTER' to reach the sub menu of the chosen parameter.
8. Refer to the instruction manual to change settings.
9. Press 'ON/OFF' switch at the end of sampling operations.
10. Press 'CLEAR' each time you need to end an action. The unit will then return to the initial configuration.

Installation

Practical use of contact plates

1. Remove the aspirating head.
2. Insert an identified, closed and prepared plate and remove the plate lid.
3. Replace the aspirating head.
4. Select required air volume and start the unit. The airflow is directed onto the agar surface of the plate.
5. At the end of the cycle, remove the aspirating head.
6. Close and remove the plate.
7. Incubate.
8. Count the colonies, record the results on the microbiological air sampling report and read the results.