Mennekes AMEDIO Proffesional+PnC 22 T2S Manual De Instrucciones Y De Instalación página 75

Current Imbalance This setting specifies whether current imbalances
Prevention should be limited. The individual phase currents
are limited so that the value difference between
the individual phase currents does not exceed
the value for "Current Imbalance Limit"
Current Imbalance Maximum value difference between individual
Limit phase currents (in A)
Minimum Current Lower current limit which is not exceeded when
Limit [A] charging
Disconnected Limit Current limit if no DLM network is connected
[A]
Clear persistent Deletes the database of the known DLM-Slaves
DLM slave DB
Block 11: Energy meter
Parameter
Reset Meter Value Behaviour (S0
and internal meter)
Send signed meter values
The format of signed meter
values
Send the meter's public key to
HTB backend
Data transfer for Tariff And Total
Usage
Meter values sampled data
(OCPP)
Meter Value Sample Interval
(OCPP)
Meter values aligned data (OCPP) List of parameters sent by the ener-
Clock aligned data interval
(OCPP)
Description
Reset of the energy meter at each
charging process
Setting that specifies whether infor-
mation concerning the tariff and
energy consumption should be dis-
played
List of parameters sent by the ener-
gy meter during a charging process
via OCPP
Interval (in seconds) for the trans-
mission of values for "Meter values
sampled data (OCPP)"
gy meter via OCPP, independent of
the charging process
Interval (in seconds) for the trans-
mission of values for "Meter values
aligned data (OCPP)"
Only if "Current Imbalance
Prevention" = "On"
Charging
system
This setting has to be made
separately in the slave web
interface
The database must be deleted
when a DLM-Slave is decom-
missioned
Necessary
for ...
Backend-
System
Not relevant for the device
Not relevant for the device
Not relevant for the device
Backend-
System
Remark
Information will be provided
by your Backend-System
provider
EN
31