Troubleshooting - Ryobi RLM5319SME Traducción De Las Instrucciones Originales

TROUBLESHOOTING

Problem
Handle not in Handle positioned incorrectly.
correct position.
Handle knobs not tightened.
Mower is not No spark.
starting.
No petrol.
Engine is fl ooded.
Starter rope pulls harder now than
when new.
Mower is hard to High grass, rear of mower housing
push. and blade are dragging in heavy
grass, or cutting height too low.
Wheel assembly needs cleaning.
Mower is vibrating Blade is unbalanced.
at higher speed.
Bent motor shaft.
Mower is not Wet grass clippings are sticking to
mulching properly. the underside of the deck.
Mower is not Cutting height set too low.
bagging properly.
Possible cause Solution
Check to be sure that lower part of handle is pushed
fully back and snapped into proper position.
Tighten handle knobs.
Use spark tester to check for proper spark plug
operation.
Fill mower with petrol. If mower still does not start,
contact a servicing dealer.
Wait 15 minutes, then try starting mower again. Do not
prime before attempting to start.
Contact a servicing dealer.
Raise the cutting height.
Clean wheel assembly.
Replace the blade.
Stop the engine, disconnect the spark plug wire from
the spark plug, and inspect for damage. Have it repaired
by an authorised service center before restarting.
Wait until the grass dries before mowing. Clean the
underside of the mower deck.
Raise the cutting height.
EN
English
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
9