Cleaning The Interior; Servicing The Maintenance Unit - Weidmuller Crimpfix L Manual De Instrucciones Original

► Clean the intermediate spaces of each crimp die; e.g.
with a blade.
1
Figure 7.8 Cleaning crimp dies
► Re-insert both crimp dies. Ensure that the groove (1) is
directed downwards in each case.
► Screw both crimp dies on tightly.
► Push the tool unit backwards again.
► Re-insert the stranded wire fixing unit and tighten it.
Additional monthly maintenance:
2
3
1
Figure 7.9 Crimp tool
► Check whether the rollers (1) on the crimp tool can move
freely.
► Check whether the rollers (2) on the ferrule-holding
tongs can move freely.
► If necessary, oil both points.
► Oil the guide pin (3) of the ferrule-holding unit.
► Oil the lateral running surfaces (4) of the ferrule-holding
unit.
► Re-insert the stranded wire fixing unit and tighten it.
2518100000/03/06.2017

7.10 Cleaning the interior

► Remove the waste container.
► Clean the inside of the machine with a brush and, if nec-
essary, with a vacuum cleaner.
Never use compressed air for cleaning the in-
side, because otherwise small parts (e.g. strip-
ping residues) become inaccessible on the inside
of the machine. This may result in malfunctions
and operational stoppages.

7.11 Servicing the maintenance unit

Figure 7.10 Tool slide
4
Quarterly
► Pull the stranded wire fixing unit forwards.
► Lubricate the contact surface (1).
► Bring the stranded wire fixing unit back into position.
1
Cleaning and maintaining the machine
1
45