Adjusting The Ferrule Cross Section; Setting The Stripping Length (Only Ls) - Weidmuller Crimpfix L Manual De Instrucciones Original

5.2 Adjusting the ferrule cross section

Figure 5.1 Ferrule cross section adjustment wheel (set: 0.5)
The adjustment wheel on the ferrule feed rail can only be
adjusted if the vibrating conveyor bowl has been rotated
beforehand to the extent that the ferrule infeed is open.
2 1
Figure 5.2 Ferrule infeed opened
► Loosen fixing screws (1) of the vibrating conveyor bowl.
► Rotate the vibrating conveyor bowl in an anti-clockwise
direction so that the ferrule infeed is open.
► Raise the adjustment wheel (2) slightly, rotate it to the
required value and let it latch back in.
► Rotate the vibrating conveyor bowl backwards up to the
stop.
► Re-apply the fixing screws (1).
2518100000/03/06.2017

5.3 Setting the stripping length (only LS)

A letter is assigned to each wire-end ferrule:
16 mm = A 14 mm = B
► Check whether the applicable letter (A, B or C) is set to
the following four components:
1. Ferrule stop (figure 3.2, 3)
2. Release device (figure 3.2, 12)
3. Wire-insertion unit (figure 3.2, 10)
4. Opening wedge (figure 3.2, 1)
Configuring the ferrule stop
Figure 5.3 Ferrule stop configuration (set: B)
► Turn the adjusting wheel with the
that the required value is underneath.
Setting up the machine
12 mm = C
Allen key
(5 mm) so
35