Dura Heat WORK BOX XTR8000 Manual Del Operador página 6

OPERATION
Position: Find a level and unobstructed location to place the unpackaged heater.
Set ON/OFF switch to ON: Press the switch located on the rear of the heater
the ON position (I). This provides electricity to the unit.(See Fig. 3).
Turn the Power/Fan Speed Dial to desired fan setting (LOW, MEDIUM, HIGH).
The first time you turn the heater on; it will display the Highest temperature
Setting of 86°F. (See Fig. 4)
Adjust Temperature Setting: Turn the Temperature Setting Dial to adjust the
temperature setting from 59-86°F. The first time you turn the dial, the LED will begin
flashing at a default of 86°F. Turn the dial to the left or right to decrease or increase
the temperature setting. After you stop turning the dial, the LED temperature display
will flash for three seconds, then the temperature will be set. (See Fig. 5)
When adjusting the Temperature Setting, you must select a temperature at least two degrees higher than the actual
temperature shown on the LED Temperature Display, or the heating element will not turn on.
When you adjust the Temperature Setting, the number on the display will flash for three seconds. Adjusting the
Temperature Setting more than two degrees below the actual temperature will cause the heating element to turn off. The
fan will continue to run.
• Turn off the heater: turn the Power/Fan Speed Dial to the OFF position. The fan will continue to run until all of the
heat has been expelled and will then turn off.
• To change the Temperature Setting display from ºF to ºC, press in on the Temperature Setting Dial for two seconds.
Press in on the dial again to change from ºC to ºF.
NOTE: If the heater is tipped over in any direction (frontward, backwards, sideways) while running, it will shut off. Return
it to an upright position and turn the Power/Fan Speed Dial to OFF. Turn Main Power Button on rear off then on. Turn
the dial back on and the heater will resume normal operation.
~ 6 ~