Changing The "Limpid" Water Filter; Cleaning The Brewing Unit - SEVERIN S2 One Touch Instrucciones

The display shows:
Â
descaling
NOTE!
The descaling process can take as long as 30 minutes.
8. As soon as the command
Please emPtY driP traY
appears on the display, empty the drip tray and the grounds container again,
clean the parts with clear water and put them back in the device.
The display shows:
Â
Please rinse container and and fill with water
US
9. Rinse the water tank thoroughly with clear water, then fill it with clear water and
put it back in the device.
10. Press the e-Select to continue.
The display shows:
Â
descaling
The descaling is complete as soon as the „Beverage selection" view is
displayed again.
22

8.3.5 Changing the "Limpid" water filter

For even water quality, the "Limpid" water filter must be changed regularly.
NOTE!
If you change the water filter immediately after the display
of a cleaning message, steps 1 and 2 can be omitted.
1. Press the menu button for at least 3 seconds and use the e-Select to select the
cleaning
menu option.
2. Then select the
insert water filter
menu option and press the e-Select.
The display shows:
Â
Please insert water filter
3. Empty the water tank and remove the water filter.
4. Insert a new water filter, fill the water tank with cold drinking water and set the
water tank on the device.
5. Press the e-Select.
The display shows:
Â
filter rinsing
The filter change is complete as soon as the „Beverage selection" view is
Â
displayed again.
8.4

Cleaning the brewing unit

In addition to an integrated cleaning program, the device also offers you the opportuni-
ty to clean the brewing unit manually. For this, the brewing unit can be removed as fol-
lows:
1. Switch the device off.
2. Remove the water tank and shake out the remaining water.
3. Open the flap of the brewing unit on the back side of the machine by pressing
down on the tabs with your thumbs and pulling towards you (Fig. 12)
4. Remove the flap completely.
Version 1 2011-04-18