Tabla de contenido
M
x 4
FIG. 7
7) Cover your work surface with a cloth or piece of cardboard to protect the finished seat. Place
the seat upside down on the work surface. Be sure the front of the swivel is placed towards
the front of the seat, ("FRONT" is stamped on top of swivel.) Place the leg assembly upside
down on the bottom of the seat and line up the holes in the swivel with the pilot holes in the
seat.
Screw the swivel into place through the access holes in the disc using the #14 x 3/4" Pan
Head Screws (M). Turn the leg assembly until the other two sets of holes line up with the
access holes in the disc and finish screwing the swivel down with the #14 x 3/4" Pan Head
Screws (M). See FIGURE 7.
FIG. 8
8) The legs are Grooved at the bottom to allow them to be cut down to different lengths. The
resulting seat heights are shown in FIGURE 8.
PAGE 6 — 135W
23½" seat height
25½" seat height
27½" seat height
29½" seat height
Tabla de contenido
