Tabla de contenido
N
x 4
FIG. 5
5) For added strength, screw a #8 x 1
screws must be inserted at such an angle so that they do not go through the other side of
the leg or top of the disc. See FIGURE 5.
M
x 4
FIG. 6
6) The top of the swivel is marked "FRONT" for your convenience. Center the Swivel (D) on
the Disc (B) lining up the screw holes in the swivel with the indentation marks on the disc.
Remove the swivel and drill a 1/8" pilot hole, 1/2" deep into the center of each indentation
mark. Fasten the swivel to the disc with the #14 x 3/4" Pan Head Screws (M). See
FIGURE 6.
/
" Black Screw (N) through each leg into the disc. The
5
8
M
A
N
B
M
NOTE: A new swivel may appear
frozen or hard to turn. It can be
loosened by twisting it a little
D
before assembly. Be sure to use
a towel or gloves to protect hands
as the edges of the swivel may
be sharp.
B
To insert screw at proper angle, the
screw head should be approximately
1/2" from the disc surface when
starting the screw.
135W — PAGE 5
Tabla de contenido
