Tabla de contenido
GLUE ALL
LEGS
FIG. 3
3) To attach the legs, place the Disc (B) top side down on your work surface. The top side
is marked with indentations for attaching the swivel later. Spread glue in each leg hole in
the disc. Put a Leg (A) in each hole and tap in place with the rubber mallet as shown in
FIGURE 3.
L
x 4
FIG. 4
4) Slip the Ring (C) over the top of the leg assembly and down into the grooves in the legs.
Make sure that the holes in the ring are centered on each leg, then drill a 1/8" pilot hole
approximately 5/8" into the legs. Fasten the ring in place using the #10 x 1½" Oval Head
Zinc Screws (L). See FIGURE 4.
PAGE 4 — 135W
A
A
B
L
C
Tabla de contenido
