Nortel Networks 2330 Manual Del Usario página 36

36 English
3
4
Ensure the PVM slot is clear of debris. Protective tape is placed
over the SO-DIMM and PVM slots during the manufacturing
process; remove this tape if it is present.
Holding the PVM by its edges, insert the module in the slot on
the Main Board, pushing down gently, but firmly, to fully seat the
module. The following figure shows the proper orientation of the
PVM in relation to the slot. If you are looking at the rear of the
router (with the service access panel removed), the key of the
PVM is on the left side.
The release latches close when the PVM is properly installed.
See the following figure.
Nortel Secure Router 2330/4134
Regulatory Information
NN47263-106 01.01 18 September 2009
Copyright © 2009- Nortel Networks. All Rights Reserved.