HOW TO CONNECT THE CORD TO A U.K. PLUG: IMPORTANT
The wires in the mains lead are coloured in accordance with the following code:
•
Green and yellow:
•
Blue:
•
Brown:
Please, read the instructions given below before connecting the cord to a
plug. If in doubt, please, consult a qualified electrician. As the colours of the
wires in the mains lead of this appliance may not correspond with the
coloured markings identifyng the terminals in your plug, proceed as follows:
the wire that is coloured Green and Yellow must be connected to the terminal
in the plug which is marked with the letter E or the Earth symbol (G), or
coloured Green or Green and Yellow.
The wire that is coloured Brown must be connected to the terminal which is
marked with the letter L or coloured Red. The wire that is coloured Blue must
be connected to the terminal which is marked with the letter N or coloured Black.
SAFETY POINTS FOR REWIRABLE OR MOULDED PLUG
The mains lead of this appliance may be already fitted with a BS1363 13A plug.
•
If your socket outlet is not suitable for the plug, then the plug must be removed (cut off if it is a moulded on
plug), the flexible cord insulation should be stripped back as appropriate and a suitable 3 pin plug fitted.
•
WARNING: Dispose of a plug that has been cut from the power supply cord, as such a plug is hazardous if
inserted in a live 13A socket outlet elsewhere in the house.
•
Should the fuse need to be replaced an ASTA marked fuse, approved to BS 1362, of the same rating must be
used.
•
Always replace the fuse cover after fitting a fuse. The plug must NOT be used if the cover is omitted or lost until
a replacement is obtained. Make certain that only the correct fuse cover is used and fitted.
•
For plugs with detachable fuse cover, the replacement must be the same as the colour insert in the base of the
plug, or as directed by the embossed wording on the base of the plug.
•
If the detachable fuse cover is lost a replacement may be purchased from a Service Centre.
•
Information for supply may also be obtained from the plug manufacturer.
ICE CREAM MAKER GELATO "GELATISSIMO"
The appliance is sold complete with all the accessories for use with fixed or removable bowl. In the original package,
the removable bowl is stored inside the fixed bowl.
IMPORTANT
ABOUT THE USE OF THE APPLIANCE
•
Hygiene is the most important aspect of ice cream making. Make sure all the parts, in particular those coming in
direct contact with the ice cream, are scrupulously clean.
•
Never turn off the freezing switch (L) when the machine is working. In case you accidentally switch it off or the power
fails, wait at least 10 minutes before turning it on again. The compressor is fitted with a safety device to prevent any
possible damage to the motor unit. Should you restart the machine immediately after it has been switched off, the
compressor will not freeze.
•
The paddle movement and the freezing plant are indipendent: the (L) button turns ON and OFF the refrigeration and the
(M) button turns ON or OFF the mixing paddle. To stop the machine, press both (M) and (L) buttons. After the machine
has been switched off, wait approximately 10 minutes before making another ice cream.
•
Variations in speed and noise during ice-cream making are also to be expected and in no way affect the unit's normal
functioning. In case the ice cream become too hard, the motor stops by itself. A safety device protects the motor from
possible damages. Should not the motor begin to work again, wait till the motor cools.
•
Keep the appliance far enough from walls and furniture, which might restrict air circulation, necessary for cooling the
unit. It is normal for warm or hot air to flow from the lateral air vents. The refrigeration process requires this.
USING THE FIXED BOWL
1).
Carefully clean all parts in direct contact with ingredients. Warning: make sure unit is unplugged before starting
cleaning.
2).
Insert the mixing paddle (B) securely into the drive shaft in the fixed bowl.
English
UK USERS ONLY
Earth
Neutral
Live
5