marklin 20755 Manual Del Usuario página 12

Function Mapping DCC
It is possible to assign functions controlled from the decoder to function buttons
of your choice (mapping). To do this an appropriate value must be entered in the
appropriate CV.
The CVs (lines) and the functions (columns) are listed in the tables on pages 40/41.
Four CVs belong to each button. For space reasons the 4 CVs were put together in
one line starting with CV 282 (Button F5).
It is basically possible to assign several functions to one button or one function to
several buttons.
Note: The programming for function mapping should be done only by experienced
users.
Individual functions can be controlled by means of SUSI depending on the design of
the decoder. These functions can be handled by the decoder as sound. The volume
levels belonging to these functions cannot be changed.
Examples of Function Mapping:
AUX 2 is to be forwards and backwards on Function 3
CV 272 & CV 372 = 8
CV 273 & CV 373 = 0
CV 274 & CV 374 = 0
CV 275 & CV 375 = 0
Sound 15 is to be shifted from forwards and backwards on Function 3 to Function 8.
The existing function at Function 8 is overwritten in the process.
CV 275 & CV 375 = 0
CV 273 & CV 373 = 0
away from Function 3
CV 274 & CV 374 = 0
CV 275 & CV 375 = 0
CV 297 & CV 397 = 0
CV 298 & CV 398 = 0
to Function 8
CV 299 & CV 399 = 0
CV 300 & CV 400 = 4
Programming the CV with the 55015 Universal Hand Controller
The decoder built into your locomotive is a further development of the previous LGB
decoder-technology. A lot more functions are available on this decoder than was
previously customary. More possibilities for making settings on the decoder are how-
ever, necessary compared to previous decoders in order to be able to adapt these
functions to your personal needs. These settings can also be done with the 55015 Uni-
versal Hand Controller. Since the Universal Hand Controller was not designed for this
decoder, the correct procedure with this controller is somewhat more involved.
We basically have to differentiate among 3 different programming methods:
• Programming by means of registers (up to CV 5)
• Programming by means of CVs (up to CV 255)
• Programming by means of pages (up to CV 1024)
The individual programming processes are described below. There is a requirement
in each case that the programming module is plugged in and the locomotive with the
decoder is standing on the corresponding track.
Programming by means of Registers (Universal-Handy 55015)
CV 1 – 5 can be programmed when programming by means of registers.
• When the programming module is plugged in, the hand controller will
show .
--
• Enter the desired CV as a two-digit number, example: „02".
• The hand controller will show
• Now, enter the desired value and confirm it by pressing on the arrow
button .
• The hand controller will again show
The programming is complete and the desired value has been programmed into the
decoder.
Programming by means of CVs
Programming by means of CVs only allows changes to CVs 1 – 5. Another method
is necessary in order to program higher CVs. Programming by means of CVs allows
changes to CVs 1 – 255.
12
d -
--
.