Oven Vent - mabe EME6063 Manual De Uso Y Cuidado E Instrucciones De Instalación

Oven Shelves
Clean the oven shelves with an abrasive
cleanser or scouring pad. After cleaning,
rinse the shelves with clean water and dry
with a clean cloth.
NOTE: Take the shelves out of the oven be-
fore you begin the self-clean cycle or they
may discolor.
Oven Light Replacement (on some models)
Be sure to let the light cover and bulb cool
completely.
Wire cover holder
To remove the cover:
1. Hold a hand under the cover so it does
2. Replace bulb with a 40-watt household

Oven Vent

On glass cooktop models, the oven is
vented through an opening at the rear of
the cooktop.
On coil cooktop models, the oven is
vented through an opening under the
right rear surface unit.
Painted Surfaces (on some models)
Painted surfaces include the sides of the
range and the sides of the door trim.
To clean the painted surfaces, use a hot,
damp cloth with a mild detergent suitable
for these surfaces. Use a clean, hot, damp
cloth to remove soap. Dry with a dry,
clean cloth.
Stainless Steel Surfaces (on some models)
Do not use a steel wool pad; it will scratch
the surface.
To clean the stainless steel surface, use
warm sudsy water or a stainless steel
Glass Window (on some models)
To clean the outside glass finish, use a
glass cleaner. Rinse and polish with a dry
cloth.
CAUTION: Before replacing your oven light bulb, turn the oven
light off and disconnect the electrical power to the range at
the main fuse or circuit breaker panel.
not fall when released. With fingers of
the same hand, firmly push back the
wire cover holder. Lift off the cover.
Do not remove any screws to remove
the cover.
appliance bulb.
To make the shelves slide more easily, ap-
ply a small amount of vegetable oil or
cooking oil to a paper towel and wipe the
edges of the oven shelves with the paper
towel.
To replace the cover:
1. Place it into groove of the light recep-
tacle. Pull wire forward to the center of
the cover until it snaps into place.
2. Connect electrical power to the range.
Never cover the opening with aluminum
foil or any other material.
Do not use steel-wool pads, commercial
oven cleaners, cleaning powders or other
abrasive cleaners. They will damage the
surface.
cleaner or polish. Always wipe the surface
in the direction of the grain. Follow the
cleaner instructions for cleaning the stain-
less steel surface.
41