Emerson EUCLID CF500BS00 Manual Del Propietário página 8

BP7519 Euclid CF500-ESF.qxp_CF500 12/2/16 11:17 AM Page 8
3.8
Align the clevis pin holes in the downrod with the holes in
the motor coupler.
Install the clevis pin and secure with the hairpin clip
(Figure 8).
The clevis pin must go through the holes in the motor
coupler. It is critical that the clevis pin in the motor coupler
is properly installed and securely tightened.
Retighten the two Phillips head set screws to secure the
downrod to the motor (Figure 8).
It is critical that the clevis pin and setscrews in the motor
coupler are properly installed and securely tightened.
Failure to verify that the pin and setscrews are properly
installed could result in the fan falling.
3.9
Make sure the grommet is properly installed in the coupler
cover, then slide the coupler cover on the downrod until it
rests on the motor housing (Figure 9).
3.10
Place the ceiling cover over the downrod (Figure 10).
Be sure that the ceiling cover and the coupler cover are
both oriented correctly (Figure 10).
3. Ceiling Fan Assembly
WARNING
!
(Continued)
HAIRPIN
CLIP
CLEVIS
PIN
CLEVIS
PIN
Figure 8
COUPLING COVER
GROMMET
Figure 9
CEILING
COVER
Figure 10
8
MOTOR
COUPLING
HAIRPIN
CLIP
RETIGHTEN
PHILLIPS HEAD
SET SCREW (2)
4.5" DOWNROD
COUPLING
COVER
MOTOR
HOUSING
4.5" DOWNROD
U.L. Model No.: CF500