General Description; Power Supply - GYS STARTIUM 330E Manual Del Usuario

Translation of the original instructions

GENERAL DESCRIPTION

The STARTIUM range is designed to charge and start all common batteries including lead-acid , electrolyte or gel
batteries, 12V et 24V.
Assembling the handle and the wheels (only for 480E, 680E and 980E) :

POWER SUPPLY

Check that the power supply and its protection (fuses) are compatible with the current required by the machine. The
device must be positioned so that the socket is easily accessible. The machine must be connected to a socket WITH
earth according to the following recommendations:
Mains voltage
Protection
charge
Charging
power
Starting
*In the event that starting a HGV proves difficult , use a 20A plug (optional).
The recommended cross-section for an extension is : 3 x 2,5 mm².
CONNECTION AND DISCONNECTION
• Before any connection to a vehicle battery, make sure
that the booster isn't connected to the mains and that the
booster's switch is set to OFF.
• Locate the + and - battery terminals. (polarity reversal can
damage the fuse).
• Keep the cables away from hot or sharp surfaces. Separate
the 2 cables properly and avoid pinching them.
Once the connector is plugged on «12V» or «24V», a LED switches on under the corresponding interface to confirm the
selected voltage input. If the selected voltage does not match the battery voltage, the charge cannot start.
STARTIUM 330E
STARTIUM 330E / 480E / 680E / 980E
STARTIUM 330E STARTIUM 480E
230V - 1 ph
16 A
800 W
6 500 W
STARTIUM 680E
230V - 1 ph 230V - 1 ph
16 A
1 700 W 2 000 W
9 000 W 10 000 W
STARTIUM 480E-680E-980E
STARTIUM 980E
230V - 1 ph
16 A 16 A*
2 000 W
12 000 W
EN
15