KRATOS SAFETY S-TOOLS SYSTEMS TS 90 001 00 Instrucciones página 9

• It may be the removable 'D' ring TS 90 001 04 that can be installed on a harness, belt, etc.
• • Item TS 90 001 03 is installed on the user's wrist, so the wrist serves as the anchor point !
• Stretch lanyard TS 90 001 06 can also be attached directly to an anchor structure.
Reference
TS 90 001 00
TS 90 001 02
TS 90 001 01
TS 90 001 03
TS 90 001 04
TS 90 001 05
TS 90 001 06
TS 90 001 08
TS 90 001 07
WARNING! Whatever combination you use, make sure that it does not interfere with the safe use of your tool.
After use, clean your S-Tools Systems accessories and keep them away from light, any source of heat, moisture, solvents, and
any sharp edges that might affect their performance.
Inspection: A visual inspection is essential before any use of the S-Tools Systems accessories.
Before each use of your S-Tools Systems accessories, make sure they show no signs of cuts, wear, discolouration, deformation,
corrosion, etc. When in doubt, they should be replaced.
Do not use S-Tools Systems accessories beyond their weight limit.
Always check the connection to the tool before each use.
S-Tools Systems that have been used to arrest a falling tool should be taken out of service
Once the anchor point and the lanyard are selected, the connections can be made using aluminium
connector, TS 90 001 07.
Always make sure the hook-and-loop closures fasten properly, because they make sure the
bracelet stays closed and holds if the tool is dropped.
Always make sure the karabiners are closed and locked (screwed inz.
Maximum allowable loads :
Max. allowable load
5 kg
2 X 5 kg
10 kg
2 kg
10 kg
2kg when used with TS 90 001 05
2 kg
5 kg
5 kg
R > 90 daN
8