Technical Specifications - RIB PRINCE 24V Importantes Instrucciones De Seguridad Para La Instalación

G
B
JP4 MUST BE LEFT OPEN.
FLASHING LIGHT (BLINKER - A+)
Connect the flashing light to outputs A+ and BLINKER, use flashing lights
ACG7061 and 24V bulbs of 20W maximum.
NB: This electronic PK2-24V board can only supply power to FLASHING
LIGHTS with inbuilt flashing circuit.
PRE-FLASHING function
The DIP 5 in the ON position enables the pre-flashing, the FLASHING
LIGHT starts blinking 3 seconds before every movement of the gate.
The DIP 5 in the OFF position disables any pre-flashing, the FLASHING
LIGHT and the motors will star at the same time.
CURRENT SENSOR ALARM
The CURRENT SENSOR, permits the obstacle detection. In fact, during
opening or closing of the gate, if any of the gate leaf finds an obstacle,
the gate reverses its movement. The obstacle detection sensitivity can be
adjusted on each motor, by the trimmers M1 and M2 (POINT C).
Should the sensor detect another obstacle during the reverse movement,
the gate will reverse another time for just 1 second and then stop. This
ALARM STATE is indicated by the FLASHING LIGHT that blinks for 1
minute. The normal gate function can be restored pressing any push button
or radio commands.
GATE OPEN INDICATOR (SIGNAL - COM)
Should you need to have an indication about the leaf position, the output
SIGNAL - COM can be connected to a 12Vdc bulb of 3W maximum. It is
turned ON when the gate is open or partially open, it is turned OFF only
when the gate is completely closed.
WE RECOMMEND NOT TO OVERLOAD THE INDICATOR OUTPUT
(SIGNAL - COM) OTHERWISE THE GATE FUNCTIONING COULD BE
COMPROMISED OR THE CONTROL BOARD COULD BE DAMAGED.
T
ECHNICAL SPECIFICATIONS
- Power supply voltage
- Frequency
- Battery power supply
- Transformer power
- Maximum absorption
- Interruptions in electricity supply
- Maximum power of gate open indicator 12Vdc 3W (equivalent to 1
- Maximum load of blinker output
- Current available for photocells and accessories 1A ±15%
- Current available on radio connector
TECHNICAL SPECIFICATIONS OF RADIO (model K2 24V crx)
- Reception frequency
- Impedance
- Sensitivity
- Time of excitation
- Time of discharge
- All inputs must be used as clean contacts as the power supply is
generated internally (secure voltage) to the card and is arranged so
as to guarantee respect of double or reinforced isolation with regard
to the parts with dangerous voltage.
- Any connection of external circuits made to the exits of the control
unit must be carried out with the guarantee of double or reinforced
isolation with regard to the parts with dangerous voltage.
- All inputs are handled by a programmed integrated circuit which
carries out an auto-control at the beginning of every movement.
36
36
230V~ ±10% (120V/60Hz
upon request)
50/60 Hz
20-24,5Vdc
130VA - primary 230Vac -
Secondary 18Vac
25 mA
100ms
bulb of 3W or 5 LED with
serial resistance of 2,2 kΩ)
24Vdc 20W
200mA
433,92MHz
52 OHM
>2,24µV
300ms
300ms