Copyright; Before You Start; Inserting / Replacing The Battery - Parkside PDM 300 C2 Manual De Instrucciones E Indicaciones De Seguridad

PARKSIDE PDM 300 C2
CAUTION! Do not expose the multimeter to any direct heat sources (e.g. heaters), direct
sunlight or strong artificial light. The device must not be exposed to spray or dripping water or
abrasive liquids. Do not use the multimeter near water. The multimeter must especially never be
immersed (do not place any containers containing liquids such as drinks, vases, etc. on the
multimeter). Make sure that the multimeter is not subject to excessive shocks or vibrations. Do not
introduce any foreign bodies into the device. Otherwise the multimeter could get damaged.

5. Copyright

All the contents of this user manual are protected by copyright and provided to the reader for
information only. Copying data and information without the prior explicit written consent of the author is
strictly forbidden. This also applies to any commercial use of the contents and information. All texts and
diagrams are up-to-date as of the date of printing.

6. Before you start

Remove the multimeter and the accessories from the packaging.
Check the multimeter and the accessories for damage. If the multimeter is damaged, do not use it.

6.1 Inserting / replacing the battery

The multimeter is powered by a 9 V block battery. The procedure for inserting or replacing the battery is
as follows:
WARNING! Switch the multimeter off and remove all measurement cables before opening it!
CAUTION! If the battery is empty, the
should be replaced as soon as possible to ensure proper functioning.
• Use the screwdriver provided to undo the top screw on the back of the multimeter and remove the
battery compartment cover by sliding it upwards.
56 - English
symbol appears on the display [1]. The battery