KENMORE ELITE 796.6155 Serie Manual De Uso página 20

INSTALLATION INSTRUCTIONS
REVERSING THE TWO-WAY DOOR (continued)
7
Lift out the grey interlock button in the side of the
door.
Make sure to remove the spring with the interlock
button and to keep the two together. Set the
interlock button aside. Do not confuse it with the
interlock buttons from the top of the outer door.
8
Remove the side lock rod.
Remove the side lock rod from the lower hinge
bracket by lifting the top end of the rod and sliding
it toward the top of the door. The spring should
remain attached to the lock rod. Set the lock rod
aside.
9
Remove the top lock rod.
a. Slide the lock rod to the right to remove it from the
hinge assembly on the left side.
b. While sliding the lock rod right, lift the right end
up and out of the guides. Set the lock rod aside.
NOTE:
Do not remove the two inner lock rods and two
interlock buttons (see page 20) located underneath
the top lock rod. They do NOT need to be reversed.
INSTALLATION INSTRUCTIONS
10
Remove the upper hinge pivot.
Once the top lock rod has been removed, the
hinge pivot can easily be removed from the hinge
assembly on the upper left and set aside.
11
Reverse the upper hinge assembly and hinge filler.
Lift out the upper hinge filler (on the right) and set it
aside.
Carefully lift the upper hinge assembly (on the left)
out of the outer door frame, using a small flat-blade
screwdriver if necessary. Rotate the hinge assembly
180 degrees and install it on the upper right side of
spring
the outer door. You will need to press firmly to install
the hinge assembly.
The hinge pivot removed in step 10 will be installed
later.
Now rotate the hinge filler 180 degrees and install it
on the upper left side of the door.
20
upper
hinge
assembly
upper
hinge
pivot
upper hinge assembly
upper hinge pivot